一套標準的全自動中空玻璃生產線，通常由入料段、清洗干燥段、檢查段、合片段和封膠段組成。它將原本分散的工序整合成了一個無縫銜接的連續作業流程：

A standard fully automatic insulated glass production line usually consists of a feeding section, a cleaning and drying section, an inspection section, a closing section, and a sealing section. It integrates the originally scattered processes into a seamless continuous workflow:

清洗與干燥：這是保證產品質量的第一道關卡。玻璃原片進入生產線后，會在30℃—55℃的恒溫水循環系統中接受徹底的刷洗和風干，確保表面無塵、無油污、無水漬，為后續的密封粘結打下堅實基礎。

Cleaning and drying: This is the first hurdle to ensure product quality. After entering the production line, the glass wafer will undergo thorough brushing and air drying in a constant temperature water circulation system at 30 ℃ -55 ℃ to ensure that the surface is dust-free, free of oil stains and water stains, laying a solid foundation for subsequent sealing and bonding.

間隔框制備與涂布：與此同時，鋁間隔框（或暖邊條）經過切割、折彎后，被灌入能吸收水分的分子篩（干燥劑）。隨后，丁基膠涂布機會在鋁框表面均勻涂上一層黑色的丁基膠，這是中空玻璃的第一道密封防線。

Preparation and coating of spacer frames: At the same time, aluminum spacer frames (or warm edge strips) are cut and bent, and then filled with molecular sieves (desiccants) that can absorb moisture. Subsequently, the butyl adhesive coating machine evenly applies a layer of black butyl adhesive on the surface of the aluminum frame, which is the first line of defense for the sealing of the insulated glass.

自動合片：清洗干凈的玻璃與涂好膠的鋁框在合片機處精準匯合。設備通過高精度的定位系統，將兩片（或三片）玻璃與鋁框壓合在一起。對于高端產品，這一步還會預留充氣口，充入氬氣等惰性氣體以提升保溫性能，充氣含量通常要求≥85%。

Automatic lamination: Clean glass and glued aluminum frame are precisely merged at the lamination machine. The device uses a high-precision positioning system to press two (or three) pieces of glass and an aluminum frame together. For high-end products, this step also reserves an inflation port to fill with inert gases such as argon to enhance insulation performance, with a typical inflation content requirement of ≥ 85%.

雙道密封：合片后的玻璃進入自動封膠機，機器會在玻璃四周的縫隙處均勻涂抹雙組份密封膠（如聚硫膠或硅酮膠）。這第二道密封不僅增強了氣密性和水密性，更決定了中空玻璃的使用壽命。

Double sealing: After lamination, the glass enters the automatic sealing machine, and the machine will evenly apply two-component sealing glue (such as polysulfide glue or silicone glue) to the gaps around the glass. This second seal not only enhances the airtightness and water tightness, but also determines the service life of the insulated glass.