
中空玻璃生產線的調試方法
時間:2022-06-22 來源:http://www.hebeiruizhi.com/ 發布人:昌盛機械
中空玻璃生產線的調試方法
Debugging method of insulating glass production line
1 將中空玻璃生產線輕置于安裝位,正確擺放生產線各段的位置次序.
1 place the insulating glass production line gently at the installation position, and correctly place the position order of each section of the production line
2 機身調平.調整機器底座上調平螺栓高度,使傳送輥、支撐尼龍輪支撐面等高,斜架上的背靠輪共面,各段相對平行,然后鎖緊螺母.
2 fuselage leveling Adjust the height of the leveling bolt on the machine base so that the supporting surfaces of the transfer roller and the supporting nylon wheel are equal in height, the back-up wheels on the inclined frame are coplanar, and each section is relatively parallel, and then lock the nut
3 將各段間需聯接的部位聯接緊固,聯接好由入料段到清洗干燥段的傳動鏈條.正確擺放風機及水箱,并按水路、風路系統圖接好風管、水管.
3 connect and fasten the parts to be connected between the sections, and connect the transmission chain from the feeding section to the cleaning and drying section Place the fan and water tank correctly, and connect the air pipe and water pipe according to the water and air system diagram

4 一體檢查機器所有緊固件連接處是否因運輸震動而松動,并逐件緊固(特別是各接線端子連接處是否松動).
4 check whether all fastener connections of the machine are loose due to transportation vibration, and tighten them one by one (especially whether the connection of each wiring terminal is loose)
5 接地線用截面積不小于4平方毫米的軟銅心黃綠絕緣線,接地電阻不大于4 歐姆.
5 the soft copper core yellow green insulated wire with a cross-sectional area of not less than 4mm2 shall be used for the grounding wire, and the grounding resistance shall not be greater than 4 ohms
6 接通氣源,檢查管路是否通暢,有無破損.氣源壓力要求0.6~0.8Mpa.
6 connect the air source and check whether the pipeline is smooth and damaged The air supply pressure shall be 0.6~0.8mpa
7 接通電源,試驗各電機的旋轉方向是否正確,各段傳動鏈輪是否靈活、平穩.
7. Turn on the power supply and test whether the rotation direction of each motor is correct and whether the drive sprocket of each section is flexible and stable
8 整機清潔,整理工作區間.
8. Clean the whole machine and arrange the working area
本文的精彩內容由中空玻璃加工設備供知識提供,本網站還有很多的精彩內容,更多的內容您可以點擊進入:http://linshi.jncsjx.com我們有專門的客服為您解答問題
The wonderful content of this article is provided by the insulating glass processing equipment. There are many wonderful content on this website. You can click to enter more content: http://linshi.jncsjx.com We have special customer service to answer your questions
- 中空玻璃加工設備革新:一體鈑金框架告別焊接,穩到零偏差,次品率直降 2026/03/27
- 丁基膠涂布機:中空玻璃氬氣鎖鮮關鍵!實測底部99.9%,邊緣95.6%全達標 2026/03/26
- 山東玻璃廠必看!大小片中空玻璃全自動封膠線,告別殘膠返工,打膠零瑕疵 2026/03/26
- 昌盛中空玻璃生產線:充氣超93%+出口俄羅斯,大玻璃穩、封膠嚴,老客戶轉介紹不斷 2026/03/25
- 雙組份打膠機:中空玻璃省工利器,全自動密封成型,告別人工短板 2026/03/25
- 全自動封膠線:三項智能節能黑科技,玻璃廠年省電費超30% 2026/03/24
- 45米全自動中空線:玻璃深加工廠的核心引擎,高效定制一步到位 2026/03/24
- 大小片中空玻璃打膠難?雙組份打膠機,告別殘膠返工,效率翻倍 2026/03/23
- 中空玻璃生產線:掌握5個核心要點,輕松洗出潔凈無瑕疵玻璃 2026/03/19
- 臥式丁基膠涂布機:中空玻璃防起霧,密封達標關鍵設備 2026/03/13

當前位置:



產品分類Product categories
聯系我們Contact us
